Additional Features:
- Output Power: 1000VA
- Output Voltages: 0-130V
- Output Frequency: 45 Hz to 5 kHz
- Output 1/Range 1 Max. Current 7.7 A (0 V to 130 V)
- Adjustable Phase Angle
- Current Source Configurations
- Sine-Wave or Square-Wave Output
- Programmable Interface (IEEE-488 and BCD)
- Low Distortion and Noise
- Single Phase Output
- Remote Control
- Dimensions H x W x D: 8.75 x 19 x 22 inches
Applications
- Avionics Testing
- Frequency Conversion
- Instrument Calibration
- DC Power Supply Testing
- Ground Power Simulation
- Position Sensor (LVDT/RVDT, Synchros, etc.) Testing
- Circuit Breaker, Fuse, etc. Testing
- Military Electronics Testing-MATE
- Gyro Testing-Microsyn and Wheel Supplies
The California Instruments 1001TC supplies approximately 9 amps on the lower voltage range of 0-130VAC. The 1001TC delivers full power down to 85% of the rated voltage ranges.
The oscillator converts user commands (manual adjustments or program statements) into the signals that drive the power amplifier.
Plug-In Oscillator
The 800T is a Manual Oscillator that is designed for applications which do not require programmable control. Typical applications would include frequency conversion, bench test, production test and general laboratory testing and evaluation.
The 800T is designed for applications requiring a sweep through the bandwidth without steps. The 800T features a large calibrated Vernier scaled dial to select the desired frequency.
- Variable-Vernier dial
- Extremely low distortion
- Frequency settable to 1%
- Phase accuracy ±%
- 20Hz to 20kHz
The California Instruments innovative modular building-block approach of combining the appropriate power controller/oscillator and power amplifier(s) allows configuration of power sources to meet specific voltage, current and output power rating requirements.
The power controller/oscillator converts user commands (manual adjustments or program statements) into the signals that drive the power amplifier. Modular "plug-in" models or " rack mount models are needed for single phase and multi-phase configurations.
Multi-Unit Single-Phase Systems
Two or more like power amplifiers can be configured to provide higher output power capabilities. Only one single-phase power controller is required.
The power amplifier produces the appropriate output frequency, amplitudes, phase angles, etc. from the precision drive signals generated by the controller/oscillator.
The T Series power amplifiers consist of ten single-phase models, and four three-phase single enclosure models. Other common features include input circuit breakers, power-on lamp and output voltage meter.
| Manufacturer | California Instruments |
|---|---|
| Condition | Used |
| Amps | 7.7 A |
| Frequency | 5 kHz |
| Phase | 1 |
| Power (VA) | 1 kVA |
| Volts | 130 V |