Sell Test Equipment

5W1000 Amplifier Research RF Amplifier

Used

The 5W1000 is a 1 GHz, 25 Watt RF Amplifier from Amplifier Research. Amplify RF and Microwave signals to measure, test, and design circuits. Applications include radio communications, cellphones, EMI testing, and much more.

Additional Features:

  • Power output, cw: up to 9 watts; minimum: 5 watts
  • Power output, cw linear (less than 1 dB compression into 50 ohms): 5 watts minimum
  • Flatness: ±1.5 dB maximum; ±1.0 dB typical
  • Frequency response (instantaneous): 500 kHz to 1000 MHz
  • Input for rated output: 1.0 milliwatt max
  • Power Gain: 37 dB minimum
  • Input Impedance: 50 ohms; VSWR 2:1 max
  • Output impedance: 50 ohms nominal
  • Mismatch tolerance (ability to operate without damage, foldback, or oscillation with any magnitude and phase of source and load impedance): 100%
  • Modulation capability (ability to reproduce faithfully AM, FM, or pulse modulation appearing on input signal): 100%
  • Noise Figure: 10 dB typical
  • Harmonic distortion: Minus 250 dBc maximum at 15 watts
  • Third-order Intercept point: 48 dBm typical
  • Primary power (select via internal taps): 100/110/120/200/208/220/240 VAC ±5%, 50/60 Hz, single phase, 110 W maximum
  • RF Connectors: Type N female
  • Cooling: Forced air (self-contained fans)

Applications

  • Sweep, cw, and pulse rf and emi susceptibility testing without bandswitching or tuning
  • Antenna and component testing, and equipment calibration
  • General laboratory instrumentation
The Amplifier Research 5W1000 is a self-contained ultra-broadband solid-state amplifier providing linear operation over the spectrum from 500 kHz to 1000 MHz. The 5W1000 is rated at 5 watts, and features instantaneous bandwidth, flat output, and immunity to even worst case load mismatch including shorted or open cable without damage or system shutdown.
ValueTronics New and Used Test Equipment, All Rights Reserved