Sell Test Equipment

DLR50-15-150 Dynaload DC Electronic Load

Used

The DLR50-15-150 is a 150 watt DC electronic load from Dynaload. Simulate loading on an electronic circuit including power supply testing, ATE applications, LED testing, and more.

 Additional Features:

  • Voltage: 50V
  • Current: 15A
  • Power: 150W
  • Overload Rating: 10%
  • Voltmeter ranges: 0-6V, 0-18V, 0-60V
  • Ammeter ranges: 0-1.8A, 0-6A, 0-18A
  • Resistance ranges: 0-.5A/V, 0-3A/V
  • Constant Current Ranges: 0-3A, 0-15A
  • Program Input: 0-6V @ 1mA
  • Program Linearity: Less than ±1% from 10% full load
  • Response Time: Less than 50 u sec
  • Constant voltage: 0-50V
  • Meter Accuracy: Less than ±3%
  • Overvoltage: 60V Max
  • Current Limit: 20A Max
  • Power Limit: 200W Max
  • AC Input: 115 VAC ±10%, 47-63 Hz
  • DC Input Terminals: Input terminals are located for convenience on both front and rear panels of most models
  • Twin Load Adjusts: Both fine and coarse load controls for greater resolution. Single load control
  • Voltmeter: Three-range voltmeter is provided for monitoring input levels
  • Ammeter: Three-range ammeter for visual measurement of current. Each range is accurate to ±3%
  • Amps per Volt ranges: The two ranges on manually controlled units represent resistive loading
  • Constant Current: This mode is used to produce a constant load on any variable source. Typical current regulation is ±1%, with less than .1% RMS ripple current. This mode is excellent when using a Dynaload as a current regulator.
  • Constant Voltage: Constant voltage regulation can be used for a variety of applications, such as battery simulation, voltage limiter, or shunt regulator
  • External programming: Terminal input is located on the rear panel for external modulation
  • Protection: Overcurrent, overpower, overvoltage, and reverse polarity

The Dynaload DLR50-15-150 is designed for economy and versatility. This standard unit offers the basic load functions of resistive loading and constant current loading. Constant voltage is also provided for battery simulation. Remote programming inputs are located on the rear panel for easy connection of a 0-6V @ 1mA dc program signal or waveform.

ValueTronics New and Used Test Equipment, All Rights Reserved