Additional Features:
- Adaptable to Specific Applications
- Operational Simplicity
- Cost effectove Noise Figure Measurements
- Includes GPIB (IEEE-488) Interface
- Bandwidth: 10% of the center frequency (nominal)
- Sensitivity: -70 dBm (minimum)
- Input Signal Level Range: 40 dB (minimum)
- Input Impedance: 50 ohm (nominal)
- Noise Figure Display Range: 0 to 19.9 dB
- Noise Figure Instrumentation Uncertainty: ±0.25 dB, 0 to 6 dB; ±0.5 dB, 6 to 12 dB; ±1.0 dB, 12 to 23 dB; ±2.0 dB, 23 to 29.9 dB
- ENR Calibration Range: 6 to 15.9 dB in 0.1 dB steps
The MT7300 series are fixed frequency units designed to operate at one of seven common intermediate frequencies designated by a model number suffix as shown below:
- A 10.7 MHz
- B 21.4 MHz
- C 30.0 MHz
- D 36.0 MHz
- E 45.0 MHz
- F 60.0 MHz
- G 70.0 MHz
The Maury MT7300 series of System Noise Monitors (SNM) are single frequency noise meters designed to meet the needs of field and production applications that demand simplicity of operation and economy in the instrumentation.
The SNM offer simplified, uncluttered front panels with only those controls required for the basic measurement and calibration functions; an indicator that tells the operator when there is sufficient signal level for a valid measurement, and a thumbwheel switch that sets the calibration of the unit for the noise generator in use (ENR). All connections are via the rear panel. These units are available with either analog or digital noise figure indicators and in either bench or rack mountable configuration.
| Manufacturer | Maury Microwave |
|---|---|
| Condition | Used |
| E | 45 MHz Frequency |
|---|