Features:
- Frequency range: 0.01 to 50 GHz
- Output power without an attenuator: –15 dBm (–20 dBm typical)
- Output power with an attenuator: –120 dBm
- Output power with an electronic attenuator: –140 dBm
- Ultra-low SSB phase noise and spurious
- +17 dBm guaranteed leveled power to 20 GHz
- <5 ms switching time for <100 MHz sweep steps
- Digital frequency sweep and digital power sweep
- Wide dynamic range with accurate output levels
- Intuitive, menu-driven front panel
- Fast analog sweep
- External FM, locked or unlocked
- External AM, log or linear
- Internal pulse generator with swept delay capability for moving target simulation
- Flexible pulse triggering including free-run, delayed, gated, and composite
- 0 to 90% AM, log or linear, over DC to 100 kHz rates
- Four FM modes for up to 10 MHz at 8 MHz rates or 100 MHz deviation at 100 Hz rates
- Internal AM, FM, and ΦM generators, each with 7 modulating waveforms
The Anritsu 68C/69B series are your best choice for A.T.E. applications. They pack the highest performance available in a single 13.3 cm package to minimize rack space. High output power assures adequate signal strength to the device under test even after A.T.E. switching and cabling losses. Accurately leveled output power to –120 dBm in 0.01 dB steps facilitates receiver sensitivity measurements. Fast 5 ms switching time maximizes system throughput. Internal list mode frees the A.T.E. controller to perform measurement analysis tasks. Optional SCPI programmability and free application drivers, including the IVICOM driver and National Instruments LabView® drivers, save you time and money in code generation and maintenance.
| Manufacturer | Anritsu |
|---|---|
| Condition | Used |
| Frequency | 50 GHz |
Looking for other manuals? Search all of our available manuals here.