DCR10-120B Sorensen DC Power Supply

Additional Features:

• Voltage: 0-10V
• Current: 0-120A
• Power: 1800W
• 115 VAC single phase input standard
• 50/60 Hz operation without derating
• 0.05% line and load regulation
• 65mV RMS ripple
• 50 ms transient response-50% change typical
• Low-Level Remote Sensing
• Low Ripple and Noise
• Direct & Master-Slave Paralleling & Series Operation
• Excellent V&C regulation, autocrossover & indicator lights
• Amperage and voltage meters
• Automatic crossover between constant voltage (CV) and constant current (CC)
• Remote voltage and resistance programming in voltage and current modes
• Adjustable current limiting (overload/short circuit protection) with automatic recovery
• Overvoltage protection with crowbar standard

The Sorensen DCR10-120B DC Power Supply, is designed for either bench or rack use, the typical DCR-B provides a highly regulated, precise DC output, adjustable over a wide range. It operates from a nominal 115 VAC and exhibits a rapid response to transients, both load and line. The supply features low-level remote sensing, manual and automatic control, direct and master-slave paralleling and series operation.

The DCR-B supplies are phase controlled type with SCR's or Triacs at the input to the transformer, followed by a passive LC filter. This design allows for a wide range of output voltages, simplicity of design, and offers large amounts of regulated power at relatively high efficiencies compared to linear regulators.